Pasco OS-8472 Dynamics Optics Carriage Manuel d'utilisateur télécharger pdf

Dynamics Optics Carriage

OS-8472

Instruction Sheet

012-09394B

800-772-8700 www.pasco.com

Introduction

The PASCO Dynamics Optics Carriage allows you to use a

dynamics track as an optics bench. The carriage works with

any aluminum PASCO dynamics track and with Basic Optics

components such as lens holders, light sources, and viewing

screens.

Component Assembly

Most Basic Optics components, including the OS-8471

Adjustable Lens Holder, snap into the wide central channel of

the carriage; the OS-8470 Light Source snaps onto the two

outer channels of the carriage. Center the component on top of

the carriage and push down to snap it in place.

Older-style components such as the metal viewing screen and

the bracket of the OS-8517A Light Source include a thumb-

screw and square nut for attachment to the central T-slot of the

carriage. Insert the thumbscrew through the hole at the base of

the component and thread it part-way into the nut (the end of

the screw should not protrude through the nut). Slide the nut

into one end of the carriage’s T-slot and tighten the thumb-

screw.

OS-8471

Adjustable Lens Holder

OS-8470

Light Source

Component attached

to central T-slot

1 2

Dynamics Optics CarriageOS-8472Instruction Sheet012-09394B800-772-8700 www.pasco.com®IntroductionThe PASCO Dynamics Optics Carriage allows you to use

®Dynamics Optics Carriage OS-84722Track AttachmentPlace the carriage on top of a dynamics track and press down to snap the outer tabs of the carriage

Pas de commentaire

Pasco OS-8472 Dynamics Optics Carriage Manuel d'utilisateur