Pasco TD-8572 HEAT ENGINE_ GAS LAW APPARATUS Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 23
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
012-06014C Heat Engine/Gas Law Apparatus
3
®
HEAT ENGINE
GAS LAW APPARATUS
Piston Dia.:
32.5mm±0.1
TD-8572
CAUTION:
Max. Pres.: 345kPa. Use Gases Only
DO NOT
Immerse in any Liquid
DO NOT Lubricate Piston or Cylinder
Pressure Port Mating Connector:
PASCO Part No. 640-021
Piston&Platform
Mass:
35.0g±0.6
m
Experiment 1: Operation of a Heat Engine
Using the one-holed stopper, connect the tubing
with the one-way valves to the air chamber and
to a connecting port on the base assembly.
Close the shut-off valve on the tubing from the
unused port.
Set a mass of 100 to 200 g on the mass platform.
Move the air chamber from an ice water bath to a
hot water bath. You will note that the air in the
chamber quickly expands through the tubing and
moves the piston up. Note also that the one-way
check valve in the tubing connecting the base
apparatus and the air chamber permits air to enter
the cylinder, while the other one-way check valve
prevents air from leaving through the branched
tube.
Equipment Setup
Note: Use a maximum mass of 200 grams in
the experiment. A larger mass will cause the
valve seals to leak.
Procedure
Note: The greater the temperature differential between the hot and cold water baths, the
greater the lift achieved through each cycle through them.
Figure 1.1. Setup for the Heat Engine
Close the shut-off
valve on the
tubing from the
unused port.
direction of
air flow
one-way check
valves
Move the air chamber back to the cold bath and note that external air is sucked into the air
chamber through the one-way valve located at the end of the branched tube. Note also that the
one-way valve in the connecting tube prevents the air from escaping from the piston, so the
height of the piston remains the same.
Repeat steps 3 and 4 until the mass has been completely lifted.
Equipment Required:
Heat Engine/Gas Law Apparatus
100 – 200 g mass
container of hot water
container of ice water
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Commentaires sur ces manuels

Pas de commentaire