Pasco PS-2110 Carbon Dioxide Gas Sensor Manuel d'utilisateur télécharger pdf

Instruction Sheet

012-07757D

Carbon Dioxide Gas Sensor

PS-2110

*See the PASCO catalog or the PASCO web site at www.pasco.com

for more information.

Introduction

The PS-2110 Carbon Dioxide Gas Sensor measures carbon

dioxide gas concentration in parts per million in gases such

as air. The sensor is designed only for educational purposes

and is not intended for environmental compliance studies.

The sensor is designed to work with a PASPORT-compatible

interface (such as the UI-5100 850 Universal Interface) and

PASCO data acquisition software (such as PASCO Cap-

stone) to measure carbon dioxide gas concentration.

The sensor includes a sensor extension cable, a 250 mL clear

plastic sampling bottle, and a stopper that fits over the sen-

sor’s probe.

Setup the Carbon Dioxide Gas Sensor

• Plug the Carbon Dioxide Gas Sensor into one of the

PASPORT input ports of a PASCO interface.

Sampling

Bottle

Sensor Extension

Cable

Threaded

Hole

Rubber

Stopper

Calibration

Button

Probe

Included Items

Sampling Bottle, Clear, 250 mL

Sensor Extension Cable

Rubber Stopper

Required Items*

PASCO Interface

PASCO Data Acquisition Software

Sensor

PASPORT

Input Port

Interface

1 2 3

Résumé du contenu

Page 1 - Carbon Dioxide Gas Sensor

Instruction Sheet012-07757DCarbon Dioxide Gas SensorPS-2110.*See the PASCO catalog or the PASCO web site at www.pasco.com for more information.Introdu

Page 2

Carbon Dioxide Gas Sensor Introduction2NOTE: If more distance is needed between the sensor and the interface, plug the sensor into the included Extens

Page 3 - Technical Support

Model No.PS-2110 Technical Support3• Connect the sensor to a PASPORT-compatible interface and start the data acquisition software. • Record data for